WLC10 — Sensing cable for water leak detection, 10 m

WLC is a Vutlan sensing cable that detects leaks along its entire length — not at a single point like a spot sensor, but wherever the cable has been laid. Liquid shorts the conductors in the braid, the resistance drops, and the connected sensor immediately reports an alarm to the data logger.

The 10-meter version is the typical choice for a small or medium-sized server room — it lets you run the cable along an entire row of cabinets or around the perimeter of a technical room.

Key information

Basic features:

• Linear detection: alarm from any point along the cable, not just from a single spot

• Section length: 10 m — ready-to-use, factory-terminated cable

• Diameter: 6.5 mm — the cable can be routed under raised floor tiles and in cable trays

• Detected liquids: clean, contaminated and distilled water, acids, alkalis, alcohols

• Maximum detection run length: 100 m per sensor

• Mounting: on standard and metal surfaces; do not lay on mesh floors

• Reusable: after drying, the cable returns to normal operation

Applications

A 10 m section is usually laid along a row of cabinets, along a wall with water connections or around the perimeter of a small technical room. With a raised floor, the cable is routed under the tiles at the lowest points of the underfloor space.

What else you will need

The WLC cable does not work on its own — it connects to a VT591 or VT594 sensor, which in turn connects to a Vutlan data logger (e.g. VT335G, VT825G, VT855G). The sensor and data logger are ordered separately. One sensor supports a detection run with a total length of up to 100 m, so shorter sections can be joined into a longer route.

Leak monitoring in practice

Leak detection makes sense when the alarm reaches someone in the middle of the night. If you are looking for a complete notification system — temperature, humidity, water leaks, power, cabinet access — check out the EnviSensor data loggers and the CE MonitorApp software in our range.